Heritage Flush Sash Window Appearance and Benefits | Deceuninck | Ceiling Wall Panels

With no clue whether the pulley would work or not, they secured it to the rafters, strung a rope through it, and pulled the staircase up to sit on the second floor, where—miraculously—they were able to get it secured.

-      The luxurious, spacious interior is a calm sanctuary, combining elegant simplicity with premium materials and beautiful details such as hidden-until-lit controls

To see how the two versions of the new Xplore XSLATE L10 perform compared to the B10 and Bobcat they are replacing, we ran our standard Passmark Software PerformanceTest 6.1, a suite of about 30 tests covering CPU, 2D graphics, 3D graphics, memory, and disk and then computes scores for each category and an overall PassMark score. The results are as follows:

Buttons are a little more difficult to press than is ideal, but they’re not terrible and they’re still tactile. The plastic flap for the charging port makes space a little limited down there, but the stock charger fits in without issue. I did test it out by rinsing it with the phone inside under a sink and submerging it, and no water got in aside from some tiny drops on the charging port flap’s gasket (which means it did what it was supposed to do). The case is rated for IP68 water and dust protection (the Pixel 2 XL comes with IP67) and MIL-STD-810G certification. I’d feel confident if I dropped my phone onto asphalt or into water with the FRE on. In fact, the FRE is actually rated even against saltwater since it completely insulates the phone from the outside world.

It also created another route for senators to take a budget resolution to the floor; the goal was to encourage promulgation of budgets that have bipartisan support and set targets for slowing the growth of the national debt.

Liu, T. Y. & Kim, C. J. Turning a surface superrepellent even to completely wetting liquids. Science 346, 1096–1100 (2014).

Experimental results showing the percent increase in (a) critical heat flux (CHF), and (b) heat transfer coefficient (HTC) for bi-conductive surfaces as compared to bare copper surfaces. Optimal performance is seen at Bond numbers of unity with a 2x increase in CHF and a 5x increase in HTC. These results highlights the importance of tuning the wavelength of spatial temperature variations, P, with the capillary length of the working fluid, λC, resulting in enhanced boiling performance over all stages of boiling.

Nolan was one of the first helmet manufacturers to use Lexan, having started with the material in 1972, so they have a great deal of experience in polycarbonate helmet manufacturing.

Up to a point, that describes the foundation, with its fetishized lowdown materials like chipboard and orange construction fencing and slightly out-of-the-way location, south of the city’s center.

Asked how, with such a bleak outlook in September, did the staff come together to get to this point, general manager Robin Roberts said the bonds between the staff and the community made it possible.

All of this you find inside of the L10. Including clever solutions to eternal issues, such as how to provide industry-standard full-size I/O ports in a device that must provide as much ingress protection as possible. How did Xplore tackle this? With external plugs like everyone else, but also by encasing all those ports in translucent silicon jackets that seal against dust and liquids even when a port plug is not in place. Impressive.

Evidently, Nolan has a very good PR Dept. However, in the real world there are still quality problems with some Nolan helmets. My N104 Evo started to develop small chips almost immediately. At first, I thought I was not being careful enough. Now, the paint is simply flaking off. There is almost no bond between the paint and the polycarbonate. It was a beautiful helmet, but now looks like it has been used as a soccer ball. The US importer is about as useful as tits on a boar hog. Nolan needs to look into this. They are getting a bad reputation among my friends.